The physical interface operates as an ISL trunk.Which of the following are correct attributes of an ASA interface that is configured to support VLAN interfaces? (Choose all that apply.) Which one of the following sets of commands should be entered first to accomplish the task? You have been assigned the task of configuring a VLAN interface on an ASA 5510. Configure the two interfaces as an EtherChannel.Configure the two interfaces as a redundant interface.Bring up a second GigabitEthernet interface on the same VLAN as the first one.Which one of the following describes the best approach to meet the requirements? A single GigabitEthernet link exists today a second link would also add redundancy. Suppose you want to double the bandwidth between an ASA’s outside interface and a neighboring switch. Which ASA command can be used to display a list of all physical interfaces? Its member priority is higher than other member interfaces.A member interface, which was previously active before it went down, regains its link status.The link status of the current active interface goes down.What must happen for a member interface to take over the active role as part of a redundant interface? The member interfaces swap the active role when one of them fails.IP addresses must be applied to the member physical interfaces of a redundant interface.Each member interface of a redundant interface cannot have its own security level.An ASA can have up to eight redundant interface pairs.